Mountain-off-road JM602 Bedienungsanleitung PDF herunterladen

MOUNTAIN OFF ROAD ENTERPRISES, LLC.

P.O. BOX 690 DELTA, COLORADO 81416

970-625-0500

970-625-3747 FAX

E-mail: info@mountainoffroad.com

www.mountainoffroad.com

INSTALLATION INSTRUCTIONS for JM602 BombProof™ MOTOR MOUNTS

Please read and understand all instructions before beginning the installation of these motor mounts. Please read

the terms and policies on the back of these instructions.

The JM602 motor mounts are designed to fit the following Jeep® vehicles: 1991-1995 YJ Wranglers equipped

with 4-cylinder engines (2.5L) . A increase in engine vibrations will be noticed with the 2.5 L engines!

STEP 1: With the Jeep® on flat level ground, apply the parking brake, block the tires so it cannot move.

Put the transmission in neutral. Using a jack, place a block of wood between the jack and the oil pan. Apply a

slight amount of pressure on the oil pan , Be careful not to jack the engine to high or you may break your radiator

shroud.

STEP 2: Remove the drivers side stock motor mount. Save the hardware that you removed because it

will be re-used. Install the BombProof™ motor mount in it’s place. Do not tighten any of the nuts or bolts at this

time. If your vehicle has a aftermarket suspension lift kit that uses spacers between the skid plate and frame to

lower the transfer case, this can cause the motor mounts to be slightly out of alignment. If you have trouble lining

-up the thru-bolt, it may be necessary to temporarily un-bolt the transmission mount from the skid plate and raise

the transmission up slightly until the thru-bolt lines up.

STEP 3: Remove the stock motor mount from the passenger side of the engine. Install the BombProof™

motor mount in it’s place .Re-use the stock hardware. Do not tighten the nuts or bolts yet. If you had un-bolted

the transmission mount from the skid plate in step 2, you can now lower it back into place and tighten the bolts

that you removed.

P.S.

D.S.

STEP 4: Tighten the bolts and nuts on the bottom of the BombProof™ motor mounts to factory specs.

Tighten the thru-bolts on the engine mounting “fork” to factory specs. Remove the floor jack. Check all of the

hardware for proper torque specs after 50 miles and every off-road use. Thank you for purchasing your Bomb-

Proof™ motor mounts from M.O.R.E.™.

Page 1 of 2

1 2

MOUNTAIN OFF ROAD ENTERPRISES, LLC. P.O. BOX 690 DELTA, COLORADO 81416 970-625-0500 970-625-3747 FAX E-mail: [email protected] www.moun

TERMS-POLICIES: FIT and TOLERANCES: These Motor Mounts are the results of countless hours of research, testing, fitting and refining.

Keine Kommentare

Mountain-off-road JM602 Bedienungsanleitung